9 Aspects to Analyze CNC Router Carving Random
9 Aspects to Analyze CNC Router Carving Random
CNC router carving random is one of the most annoying things. It is not like the fault, such as carving router bits are broken or Z-axis doesn't work, which generally won't waste plates. But cnc router carving random will waste an entire workpiece.
Many customers are very angry at it, and immediately thought of cnc router itself quality problems. In fact, it is mostly caused by incorrect operation.
We can analyze cnc router caving random from 9 sides:
1. Control card cause of cnc router carving at random:
Check if the control card of cnc machine is normal;
2. Incorrect file path leads to cnc router carving disorderly:
After finish carving path, check whether the file path format of diamond tools is correct.
For example, Wentai should be saved as *.nc;
AC should be saved as *.mmg.
3. Cnc router carving random caused by damaged edited file:
If the file format is right, see if the edited file, graphics or word, had been damaged;
If yes, correct them timely;
4. Examine software is functioning properly:
Check if Weihong software (NC Studio) or DSP handle control system had been damaged by virus:
The best way is:
(1) To Weihong software: uninstall first, then reinstall;
(2) To DSP handle system: format data inside, then re-adjust parameters according to instruction;
5. Inspect software setting:
Before usage, inspect software setting first:
If selected target exceeds working area, please re-adjust it;
6. Distorting cnc router carving lead by static interference:
Check whether exist static interfere factors, such as new added electric equipment interfered with each other, inverter interference, and so on.
7. Driver fault or current subdivision settings mistakenly:
8. Cnc router carving in a mess resulted from data line failure:
(1) Check whether computer and cnc router machine are in good connection;
(2) If ground wire of router machine is connected properly;
9. Computer problem results in cnc router carving messily;
(1) USB port is damaged;
Please change another USB port to try;
(2) If the computer has attacked by virus;
(3) Computer had been broken, such as system problem;
Please reinstall the operating system, and detect virus again;
Besides Analysis CNC Router Carving Random, you may also interest in:
(1) Ten Aspects to Analyze Tool Breakage (Ⅰ);
(2) CNC Router Precautions for Use (Ⅰ).
News for Thursday 18 December, 2014
View all news for Thursday 18 December, 2014 on one page
Recent News
- Tuesday 16 December, 2014
- Friday 12 December, 2014
- Thursday 11 December, 2014
- Wednesday 10 December, 2014
- Tuesday 09 December, 2014